Tangit PVC-U Adhesive

Features and Benefits

For bonding thermoplastic pressure pipe systems made of rigid PVC acc. to EN 1452.
Suitable for pressureless pipe systems (draining of sewage) acc. to EN 1329.
For installation and repair work (e.g., drainpipes).
Ideally suited for the structural bonding of PVC boards and tiles (e.g. drip pans, casings).
Plastic piping systems for industrial applications acc. EN ISO 15493.

Product Advantages

Long open time of 4 minutes.
Easy bonding, even of larger dimensions (one person sufficient for pipes up to 80 mm).
Easy and clean handling.
Higher security thanks to excellent gap-bridging capability (low flow value).
Maximum leak protection.
The bonded joints are as resistant as the respective pipe material (exception: concentrated acids).
Meets the requirements of EN 14814 and EN 14680.
Complies with EN 1329 for discharging water with plastic piping systems.

Packaging Details

125g Tube
250g Can (with and without brush)
500g Can (with and without brush)
1kg Can (with and without brush)

Caption language

Visit our How-to Video section

Intended
Use

For bonding thermoplastic pressure pipe systems made of rigid PVC acc. to EN 1452.
Required amount: Sufficient for approx. 30 bonds at d = 63 mm (calculated for 500 g).

Please note:

Open fire and sparking must be avoided at all costs.
Ensure good airing and ventilation of the working area.
Wear suitable protective clothing during work.
Please also refer to our Technical Data Sheet and Safety Data Sheet.

Applications

Step 1

Cut pipes: Use a pipe cutter or a light saw to bring the pipe to an accurate length. Make sure to cut it at the right angles.

Step 2

Chamfer pipe ends: Chamfer the pipe ends with a chamfering tool. A file can be used as well.

Step 3

Debur pipe ends: use a deburrer to debur pipe ends.

Step 4

Measure insertion depth.

Step 5

Mark depth: following, mark the insertion depth at the end of the pipe.

Step 6

Clean pipe and fitting: ensure that both, the pipe and the fitting, are perfectly cleaned. Use a clean piece of paper tissue for each. Surfaces to be bonded must be completely dry before applying the adhesive.

Step 7

Stir the product and soak the brush well with the adhesive.

Step 8

Apply adhesive on the inside of the fitting: Slightly apply a thin layer of Tangit on the inside of the fitting in the direction towards the end of the pipe.

Step 9

Apply adhesive to the pipe end: cover the marked area of the pipe and actively, apply a thicker layer to the pipe end with firm brush pressure.

Step 10

Insert pipe into the fitting: Immediately afterwards, insert the pipe into the fitting to its full depth without twisting and align them correctly. Then, carefully remove the excess adhesive with absorbent paper